Spray release agent

TRS Release Spray is also ideal for making silicone rubber surfaces wettable. In addition, the release spray acts as an insulating layer and extends the life of the molds, especially when working with epoxy resins.

The fine spray facilitates applications in complex and multi-angled molds. The release spray can also be used as a sliding layer by multiple spraying without intermediate polishing. This is necessary, for example, in the production of wound components such as cylindrical tubes in order to be able to extract the winding cores again.

in progress
Shake the can well before use. Spray from a distance of 20 - 30 cm. In hard-to-reach areas, you can also spray obliquely or overhead for short periods.

The image shows the importance of homogenizing liquid release agents well before processing:

1.) Stirred or shaken thoroughly

2.) After a few days of rest, the active ingredient settles and the solvent separates on the surface. If the two are not mixed thoroughly again before processing, there is a risk that almost only solvent is applied during the application. The separation effect is then correspondingly poor or does not occur at all.

New molds are treated 2 - 3 times, with each coat lightly hand-polished with a soft cotton cloth immediately after application. A matte surface is desirable. High-gloss polishing is not recommended, as this removes the film to such an extent that the release effect may be lost.

Leave to dry for approx. 30 minutes on silicone rubber, then the surface can be coated, e.g. with EP gelcoat without eyelets.

Residues in the mold can be removed with mineral spirits or mechanically with steel wool.

Physical-chemical characteristics

Form: aerosol
Color: white
Odor: Characteristic
Density at 20°C (DIN 51757 standard): 0.64 g/ml
Active ingredient content: 2.95%.
Flash point: > -97 °C
Viscosity at 20 °C (4 mm outlet cup DIN EN ISO 2431): < 59 sec

Storage temperature: Between 10°C and 30°C

Important note on substrates:
This product contains hydrocarbon solvents. It also contains a small amount (< 2%) of aromatic hydrocarbons. Some plastic surfaces (e.g. polycarbonate, Plexiglas®, various paints, fillers) are dissolved in such a way that it is not possible to take an impression. It is essential to check this before use, either by referring to the resistance lists of the materials or by carrying out a preliminary test.

Contains no silicone or CFC.

400 ml pack.